- sealing and installation of PVC, wood and aluminium window and door joinery -
- installation of window sills and stairs
- thermal insulation of central heating, water and sewage systems, sealing of installation ducts
- thermal insulation of roofs and ceilings
- filling gaps in thermal insulation when insulating buildings
• Soundproofing: up to 61dB
• Conductivity coefficient: 0,032 W/mK
• Operating/substrate temperature: from +5oC to +30oC (optimal +20oC)
• Can temperature: +20oC
• Skin formation time: 6 to 14 minutes. (at 20oC and RH 60%)
• Pre-treatment time: 45 min. (at 20oC, RH 90%)
• Full cure: 24 h
• Thermal resistance (after curing): from -50oC to +90oC
• Flammability class: B3 according to DIN4102
• Capacity: up to 45 litres
Thoroughly clean and degrease the working substrate. Before use, make sure that the can has a positive temperature (+20°C). Moisten the working surfaces with water, e.g. using a sprayer. Shake the can firmly (for approx. 30 seconds) in order to mix the ingredients thoroughly. Attach the gun to the can, the working position is the can position upside down. Apply foam from bottom to top of the gap. Gaps should be filled to 60% depth, but not more than 4 cm per layer, wider than 4 cm should be filled in layers, each layer should be moistened with water after application, using e.g. a sprayer. Remove excess foam after curing by mechanical methods (e.g. knife). After full curing of the foam, it should be protected against UV rays using e.g. silicone masks, plaster, paints.
